The DRV 500 from CM Process Solutions is a fully automatic boot washing machine that washes both the soles and sides of employees rubber boots, its designed to be used as an obligatory entrance and exit for areas where employees footwear need to be cleaned.
Operational Design
The DRV 500 is fully automatic with sensors mounted at each end of the machine within the handrail, The operator simply steps on to the unit and the sensor initiates the rotation of the 6 brushes, two of the brushes are mounted horizontally for cleaning the soles of the boot, the other four are vertically inclined which facilitate the cleaning of the sides of the boot.
Water and the chosen sanitizer chemical are sprayed onto the brushes from the spray bar mounted close to the brushes, the chemical can be simply adjusted by a needle valve mounted on the incoming side of the water supply pipework.
The machine has a lockable storage compartment where chemical can be stored within the machine.
Each brush is individually controlled by its own motor.
Safety Features
Our range of boot and sole washers are designed with safety in mind, an emergency stop push button is mounted within the handrail to cut the machines operation within an emergency situation, a reset pushbutton is installed to ensure that the machine is safe to start operation.
The steps on each are non-slip stainless steel, handrails are positioned each side of the machine for the operator to steady themselves on while walking over the sole washer machine.
Sanitary Design
As with all our equipment our range of sole washers are built using hygienic principles in mind, the brushes can be easily removed without the use of tools by simply lifting the stainless steel cover and sliding it off the motor cam.
The construction of the machine is manufactured from 304 grade stainless steel, surfaces are radiused, so water drains easily form the frame.
